User Manual

User Manual of Network Positioning System
© Hikvision
33
Chapter 5 System Configuration
5.1 Storage Settings
Before you start:
To configure record settings, make sure that you have the network storage device within the
network or the memory card inserted in the network positioning system.
5.1.1 Configuring Recording Schedule
Purpose:
There are two kinds of recording for the network positioning system: manual recording and
scheduled recording. In this section, you can follow the instructions to configure the scheduled
recording. By default, the record files of scheduled recording are stored in the memory card (if
supported) or in the network disk.
Steps:
1. Enter the Record Schedule settings interface:
Configuration > Storage > Schedule Settings > Record Schedule
Figure 5-1 Recording Schedule Interface
2. Check the checkbox of Enable to enable scheduled recording.
3. To set the advanced settings of the network positioning system, click to enter
the advanced settings interface.