User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask for PTZ Camera Channel
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Rapid Focus
- Chapter 5 Storage and Playback
- Chapter 6 Events Settings
- Chapter 7 System Settings
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
87
9. Click tab to select the linkage method taken for the object removal alarm, Notify
Surveillance Center, Send Email, Upload to FTP, Trigger Channel, Smart Tracking and Trigger Alarm
Output are selectable. Refer to Section 6.1.1 Configuring Motion Detection for more details.
Click button to save the settings.
6.3 Behavior Analysis
Purpose:
Multiple rules can be configured for different requirements to do intelligent analysis.
Note:
Behavior analysis is only available for panoramic camera channel. If the camera supports more than
one panoramic channel, select a channel and start configuration.
6.3.1 Configuring Overlay & Capture
Steps:
1. Enter the Behavior Analysis configuration interface:
Configuration > Behavior Analysis > Overlay & Capture
Figure 6-19 Overlay & Capture
2. Set the display information:
Display VCA info. on Stream: The green frames will be displayed on the target if in a live view or
playback.
Display Target info. on Alarm Picture: There will be a frame on the target on the uploaded alarm
picture if the checkbox is checked.
Display Rule info. on Alarm Picture: The captured target and the configured area will be framed
on the alarm picture.