User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask for PTZ Camera Channel
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Rapid Focus
- Chapter 5 Storage and Playback
- Chapter 6 Events Settings
- Chapter 7 System Settings
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
97
Restore Default: Click to restore all the settings in advanced configuration to the factory
default.
6.5 People Density
This function can detect the level of people density in the configured area.
6.5.1 Rule
Purpose:
Set up detection areas, density levels and linkage method on this page.
Figure 6-34 People Density Rule configuration
Steps:
1. Click and draw detection area on live image. Click to clear all the areas.
Note:
You can set 8 areas at most, and the area can be set as polygon of 10 sides at most.
2. Set target size as Large-size Target (40*40 pixel) or Small-size Target (20*20 pixel) for each detection
area from the dropdown list.
Note:
Click or , a frame of 40*40 pixel or 20*20 pixel will be showed on live picture. Choose the
corresponding target size by comparing the target size with frame size.