User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask for PTZ Camera Channel
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Rapid Focus
- Chapter 5 Storage and Playback
- Chapter 6 Events Settings
- Chapter 7 System Settings
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
95
(1) Select a Detection Scene from the dropdown list.
(2) Adjust the live image to a desired scene. you can use PTZ control panel or click to locate a
scene with a face. Click Lock to lock PTZ for further settings.
(3) Click and draw detection area on live image.
(4) Click and draw Min. Pupil Distance on live image.
(5) Input Mounting Height of the camera.
(6) Save the settings for the detection scene.
(7) Repeat the steps to set other detection scenes.
(8) Save the settings
3. Click to enable camera patrols the detection scenes following configured order and
dwell time, and capture faces during its patrol.
Figure 6-32 Patrol Schedule
(1) Click the set blue time bar.
(2) Click Configuration in the pop-up bubble.
(3) Add detection scenes, adjust the patrol sequence and set dwell time for each detection scene.
(4) Save the settings by clicking OK.
(5) You can copy the settings of a day to other days by click on right end of the time bar.
4. Click to set linkage method. Refer to Section 6.1.1 Configuring Motion Detection for
detailed configuration.
6.4.3 Advanced Configuration
Purpose:
The following contents are about how to configure the parameters of face capture algorithm.
Note:
Face Capture Version shows current algorithm version, which cannot be edited.