User Manual

User Manual of PanoVu Series Network Camera
49
 Non-motor Vehicle: Choose the Non-motor Vehicle when you monitor the non-motor
vehicles.
 Motor Vehicle: Choose the Motor Vehicle when you monitor the motor vehicles.
 Auto: You are recommended to set it to be auto when the application scene of the camera is
complicated.
 Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low, Medium or
High.
 Auto Scan Speed: The scan speed can be set from level 1 to 40.
 Max. Tilt-angle: Set the tilt-angle of the speed dome from the drop-down list.
 Zooming Speed: The zoom speed is adjustable from level 1 to 3.
 PTZ OSD: Set the on-screen display duration of the PTZ status.
 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds, 10 seconds,
Always Close or Always Open.
 PT Status: Set the azimuth angle display duration while panning and tilting as 2 seconds, 5
seconds, 10 seconds, Always Close or Always Open.
 Preset Status: Set the preset name display duration while calling the preset as 2 seconds, 5
seconds, 10 seconds, Always Close or Always Open.
 Power-off Memory: The camera can resume its previous PTZ status or actions after it restarted
from a power-off. You can set the time point of which the camera resumes its PTZ status. You can
set it to resume the status of 30 seconds, 60 seconds, 300 seconds or 600 seconds before power-off.
3. Click to save the settings.
4.2.2 Configuring PTZ Limits
Purpose:
The camera can be programmed to move within the configurable PTZ limits (left/right, up/down).
Steps:
1. Enter the Limit configuration interface:
Configuration > PTZ > Limit