Operation Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Configuring Eagle Vision Focus
- Chapter 5 Storage and Playback
- Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
- 6.2 Smart Event Configuration
- 6.3 VCA Configuration
- Chapter 7 Maintenance
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
77
Figure 6-15 VCA Configuration (Camera 2 and Camera 3)
The setting of VCA configuration can be divided into three modes.
Behavior Analysis Configuration
For the configuration of behavior analysis, refer to the flowchart below.
Select Behavior Analysis as VCA Resource.
Set Overlay & Capture.
Set Zoom Ratio.
Set parameters in VCA > Advanced
Configuration.
Set scene parameters and rules in VCA > Scene
Configuration.
Set Arming Schedule, Alarm Linkage and Scene
Auto-switch (optional) of the scene.
Save the settings.
Figure 6-16 Flowchart of Configuring Behavior Analysis
Behavior Analysis & Face Capture Configuration
For the configuration of behavior analysis & face capture, refer to the flowchart below.