Operation Manual
Table Of Contents
- About This Document
 - Chapter 1 Activating and Accessing to the Camera
 - Chapter 2 Setting Local Parameters and Network
 - Chapter 3 Live View
 - Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
 - 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
 - 4.2.2 Configuring PTZ Limits
 - 4.2.3 Configuring Initial Position
 - 4.2.4 Configuring Park Action
 - 4.2.5 Configuring Privacy Mask
 - 4.2.6 Configuring Scheduled Tasks
 - 4.2.7 Clearing PTZ Configurations
 - 4.2.8 Configuring PTZ Control Priority
 - 4.2.9 Configuring Panorama Tracking
 - 4.2.10 Configuring Eagle Vision Focus
 
 
 - Chapter 5 Storage and Playback
 - Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
 - 6.2 Smart Event Configuration
 - 6.3 VCA Configuration
 
 - Chapter 7 Maintenance
 - Appendix
- Appendix 1 SADP Software Introduction
 - Appendix 2 Statics, Interference Lightning and Surge Protection
 - Appendix 3 Waterproof
 - Appendix 4 Bubble Maintenance
 - Appendix 5 RS-485 Bus Connection
 - Appendix 6 24VAC Wire Gauge & Transmission Distance
 - Appendix 7 12VDC Wire Gauge & Transmission Distance
 - Appendix 8 Table of Wire Gauge Standards
 - Appendix 9 Alarm In/Out Connections
 - Appendix 10 Camera Function Description
 
 
User Manual of PanoVu Series Network Camera 
58 
5.1.3  Configuring Record Schedule 
Before you start: 
Make sure a local memory card is inserted in the camera or the network storage is added to the 
camera. 
Purpose: 
There are two kinds of recording for the cameras: manual recording and scheduled recording. In 
this section, you can follow the instructions to configure the scheduled recording. By default, the 
record files of scheduled recording are stored in the memory card (if supported) or in the network 
disk. 
Steps: 
1.  Enter the Record Schedule settings interface: 
Configuration > Storage > Schedule Settings > Record Schedule   
Figure 5-5 Record Schedule Interface 
2.  Check the Enable checkbox to enable scheduled recording. 
3.  To set the advanced settings of the camera, click    to enter the advanced settings 
interface. 
Figure 5-6 Record Parameters 










