User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Configuring Eagle Vision Focus
- Chapter 5 Storage and Playback
- Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
- 6.2 Smart Event Configuration
- 6.3 VCA Configuration
- Chapter 7 Maintenance
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
88
2) Draw the Detection Area: Click on the tool bar of the live view panel. Click the
mouse to draw an area on the live view panel. Right click the mouse to finish. Click Save to
save the settings.
3) Draw the Minimum Pupil Distance: Click on the tool bar of the live view panel. Drag
the mouse to draw a pupil distance on the live view panel. The system will filter the
objects with a pupil distance which is less than the configured value.
4) Click to save the settings.
6.3.9 Rule Configuration Demonstration
This section provides detailed configuration steps for each rule.
Line Crossing
Purpose:
This function can be used for detecting people, vehicles and objects traversing a set virtual plane.
The traversing direction can be set as bidirectional, from left to right or from right to left. The
alarm will be triggered if the rule is broken.
Steps:
1. Create new rule: Click add a new rule.
2. Select rule type: Click the dropdown list and select Line Crossing as the rule type.
Figure 6-31 Select Rule Type
3. Configure the rule area:
Click on the tool bar of the live view panel. Adjust the position and length of the line on
the live view panel.