User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Configuring Eagle Vision Focus
- Chapter 5 Storage and Playback
- Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
- 6.2 Smart Event Configuration
- 6.3 VCA Configuration
- Chapter 7 Maintenance
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
82
Restart VCA: Click Restart to restart the VCA function.
4. Adjust the Capture Parameters. (When VCA resource is selected as Face Capture.)
Generation Speed: Range [1-5], the speed for generating the target frame (green) when the
person enters the detection region. If you increase this parameter, the target will generate
faster and also the false detection rate will rise. In general, it is recommended to use the
default value.
Capture Times: Range [1-10], the times for capturing the person who passes through the
detection region. If the person passes very fast, the capture times may be less than the set
parameter.
Sensitivity: Range [1-5], the sensitivity for face detection. Larger value means higher
sensitivity, more faces will be detected and also false detection rate will rise. In general, it is
recommended to use the default value. Decrease the value if the false detection rate is high.
Capture Interval: Range [1-255], the interval between two capture actions.
Capture Sensitivity: Range [0-20], the threshold for judging whether to do face capture.
5. Click to save the settings.
6.3.5 Scene Configuration
Purpose:
The network camera supports patrol tracking for multiple scenes. At most 10 scenes can be
supported by the network camera. At most 8 rules can be configured for a single scene. You can
configure the rules for the scene on your demand.
Steps:
1. Enter the Scene Configuration interface:
Go to Configuration > VCA > Scene Configuration.
2. Create a scene. (Optional)
Create a Scene:
1) Add New Scene: Click New Scene to create a new scene.
2) Control the PTZ to get the required scene.
3) Set the scene parameters.
4) Click to save the settings.
5) After saving the scene position, you can click Call to call the scene position.
3. Select a scene to enter the scene VCA configuration interface.
4. You can configure the scene parameters, rule, arming schedule and alarm linkage.
Scene Parameters
Steps:
1. Enter Scene Parameters settings interface (here we take Scene 1 as an example):
Configuration > VCA > Scene Configuration > Scene 1 > Scene Parameters