User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Configuring Eagle Vision Focus
- Chapter 5 Storage and Playback
- Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
- 6.2 Smart Event Configuration
- 6.3 VCA Configuration
- Chapter 7 Maintenance
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
79
Figure 6-19 Overlay & Capture
2. Check the check box to enable the Intelligent Analysis. And you can check the current version
for the selected VCA analysis module.
3. Set the display information:
If you select to display the target info and rule info on the alarm picture are supported; you
can enable the functions by checking the corresponding checkbox on your demand.
And if you check the checkbox of display target info and rule on stream, the information
will be added to the video stream, and the overlay will be displayed if you get live view or
play back by the VS Player.
4. Set the Snapshot:
You can check the checkbox to upload JPEG image to surveillance center when VCA alarm
occurs.
You can also set the quality and resolution of the picture separately.
5. Click to save the settings.
6.3.3 Zooming Ratio
Steps:
1. Enter the Zooming Ratio settings interface:
Configuration > VCA > Zooming Ratio
2. Configure the Zoom Ratio parameters: Set the appropriate tracking zooming ratio with the PTZ
control panel.