User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Configuring Eagle Vision Focus
- Chapter 5 Storage and Playback
- Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
- 6.2 Smart Event Configuration
- 6.3 VCA Configuration
- Chapter 7 Maintenance
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
71
4. Click tab to enter the arming schedule setting interface. The arming
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Step 5 in Section 6.1.1 Configuring Motion Detection.
5. Click tab to select the linkage method taken for the video loss alarm. Send
Email, Notify Surveillance Center, and Trigger Alarm Output are selectable. Refer to Step 6 in
Section 6.1.1 Configuring Motion Detection.
6. Click to save the settings.
6.1.3 Configuring Video Loss Alarm
Steps:
1. Enter the Video Loss setting interface:
Configuration > Event > Basic Event > Video Loss
Figure 6-8 Video Loss
2. Check the Enable checkbox to enable the video loss detection.
3. Click tab to enter the arming schedule setting interface. The arming
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Step 5 in Section 6.1.1 Configuring Motion Detection.
4. Click tab to select the linkage method taken for the video loss alarm. Send
Email, Notify Surveillance Center, and Trigger Alarm Output are selectable. Refer to Step 6 in
Section 6.1.1 Configuring Motion Detection.
5. Click to save the settings.