User Manual
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Configuring Eagle Vision Focus
- Chapter 5 Storage and Playback
- Chapter 6 Alarm and Events
- 6.1 Basic Event Configuration
- 6.2 Smart Event Configuration
- 6.3 VCA Configuration
- Chapter 7 Maintenance
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
40
Configuration >Video/Audio > ROI
Figure 3-20 Region of Interest
Stream Type:
You can set the ROI function for main stream, sub-stream and third stream. Select a stream type
and then configure the ROI settings.
Fixed Region: The fixed region encoding is the ROI encoding for the manually configured area.
And you can choose the Image Quality Enhancing level for ROI encoding, and you can also
name the ROI area.
Steps:
1. Select a Region No..
2. Check the Enable checkbox under Fixed Region.
3. Select the region from the dropdown list for ROI settings. There are four fixed regions
selectable.
4. Click , and then drag the mouse to draw the region of interest on the live video.
5. Adjust the ROI level from 1 to 6. The higher the value, the better image quality in the red
frame.
6. Enter a Region Name and click Save to save the settings.
Dynamic Region: The device can automatically calculate the region with motion. Set the Image
Quality Enhancing level for ROI encoding.
Steps:
1. Check the Face Tracking checkbox.
When the face detection is triggered, the image quality of the face will be increased.
2. Respectively set the ROI level. The higher the value, the better image quality in the red
frame.
3. Click Save to save the settings.