Quick Start Guide
Table Of Contents
- 1 Overview
- 1.1 Speed Dome Overview
- 1.1.1 Overview of Type I Speed Dome
- 1.1.2 Overview of Type II Speed Dome
- 1.1.3 Overview of Type III Speed Dome
- 1.1.4 Overview of Type IV Speed Dome
- 1.1.5 Overview of Type V Speed Dome
- 1.1.6 Overview of Type VI Speed Dome
- 1.1.7 Overview of Type VII Speed Dome
- 1.1.8 Overview of Type VIII Speed Dome
- 1.1.9 Overview of Type IX Speed Dome
- 1.2 Cable Interfaces
- 1.3 Alarm Output
- 1.1 Speed Dome Overview
- 2 Installation
- 2.1 Installing Type I Speed Dome
- 2.2 Installing Type II Speed Dome
- 2.3 Installing Type III Speed Dome
- 2.4 Installing Type IV Speed Dome
- 2.5 Installing Type V Speed Dome
- 2.6 Installing Type VI and VII Speed Dome
- 2.7 Installing Type VIII Speed Dome
- 2.8 Installing Type IX Speed Dome
- 2.9 Installation of Network Cable Waterproof Jacket
- 2.10 Installation of Water-proof Tape
- 2.11 Protective Measures for Outdoor Installation
- 3 Activate and Access Network Camera
Network Speed DomeยทQuick Start Guide
9
Protective Sticker
Figure 2-4 Remove the Protective Accessories for Integrated Speed Some
3. If the speed dome supports PoE (Power over Ethernet) function, you can switch the
PoE+ and Hi-PoE function for the speed dome. If PoE function is not supported, skip
this step.
1
2
ON
Figure 2-5 PoE+ and Hi-PoE Switch
Note:
If you choose Hi-PoE, a Hi-PoE adapter must be connected. The Hi-PoE module
connection is shown in Figure 2-6.
1
2
3 4
Network Speed Dome
Ethernet
1: Power Indicator
2: PORT Indicator
3: DATA & POWER OUT
4: DATA IN
Figure 2-6 Hi-PoE Connection