User Manual

Chapter 9 Event and Alarm
This part introduces the conguraon of events. The device takes certain response to triggered
alarm.
9.1 Basic Event
9.1.1 Set Moon Detecon
This funcon detects moving objects in the detecon region and trigger linkage acons.
Steps
1. Go to
Conguraon → Event → Basic Event → Moon Detecon .
2. Check Enable Moon Detecon.
3. Oponal: (Only available in PTZ channel) Check Enable Moon Detecon in PTZ Control, and
the device detects moving targets in PTZ movement.
4.
Oponal: Highlight moving objects in green.
1) Check Enable Dynamic Analysis for Moon.
2) Go to
Conguraon → Local to enable Rules.
5. Select Conguraon Mode. Normal mode and expert mode are selectable.
-
For the informaon about normal mode, see Normal Mode .
-
For the
informaon about expert mode, see Expert Mode .
6. Set the arming schedule. See Set Arming Schedule for details.
7. Set linkage methods. See Linkage Method
Sengs for details.
8. Click Save.
Normal Mode
You can set moon detecon parameters according to the device default parameters.
Steps
1. Select normal mode in Conguraon.
2. Set the
sensivity of normal mode. The higher the value of sensivity is, the more sensive the
moon detecon is. If the sensivity is set to 0, moon detecon and dynamic analysis do not
take eect.
3. Click Draw Area. Click and drag the mouse on the live video, then release the mouse to nsh
drawing one area.
Network Speed Dome & Posioning System User Manual
56