User Manual

12.13.2 Set IP Address Filter
IP address lter is a tool for access control. You can enable the IP address lter to allow or forbid
the visits from the certain IP addresses.
IP address refers to IPv4.
Steps
1. Go to
Conguraon → System → Security → IP Address Filter .
2.
Check Enable IP Address Filter.
3. Select the type of IP address lter.
Forbidden IP addresses in the list cannot access the device.
Allowed Only IP addresses in the list can access the device.
4. Edit the IP address lter list.
Add Add a new IP address or IP address range to the list.
Modify Modify the selected IP address or IP address range in the list.
Delete Delete the selected IP address or IP address range in the list.
5. Click Save.
12.13.3 Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identy authencaon,
which improves the security of remote access.
Steps
1. Go to
Conguraon → Network → Advanced Sengs → HTTPS .
2. Check Enable.
3. Oponal: Check HTTPS Browsing to access the device only via HTTPS protocol.
4. Select a server
cercate.
Note
• Complete
cercate management before selecng server cercate. Refer to Cercate
Management for detailed informaon.
• If the funcon is abnormal, check if the selected cercate is abnormal in Cercate
Management.
5. Click Save.
Network Speed Dome & Posioning System User Manual
92