Quick Start Guide
Table Of Contents
- 1 Overview
- 1.1 Speed Dome Overview
- 1.1.1 Overview of Type I Speed Dome
- 1.1.2 Overview of Type II Speed Dome
- 1.1.3 Overview of Type III Speed Dome
- 1.1.4 Overview of Type IV Speed Dome
- 1.1.5 Overview of Type V Speed Dome
- 1.1.6 Overview of Type VI Speed Dome
- 1.1.7 Overview of Type VII Speed Dome
- 1.1.8 Overview of Type VIII Speed Dome
- 1.1.9 Overview of Type IX Speed Dome
- 1.2 Cable Interfaces
- 1.3 Alarm Output
- 1.1 Speed Dome Overview
- 2 Installation
- 2.1 Installing Type I Speed Dome
- 2.2 Installing Type II Speed Dome
- 2.3 Installing Type III Speed Dome
- 2.4 Installing Type IV Speed Dome
- 2.5 Installing Type V Speed Dome
- 2.6 Installing Type VI and VII Speed Dome
- 2.7 Installing Type VIII Speed Dome
- 2.8 Installing Type IX Speed Dome
- 2.9 Installation of Network Cable Waterproof Jacket
- 2.10 Installation of Water-proof Tape
- 2.11 Protective Measures for Outdoor Installation
- 3 Activate and Access Network Camera
Network Speed Dome·Quick Start Guide
32
Figure 2-51 Door on Bracket
5. Align the speed dome with the head cover. Use the wrench to tighten the lock screws.
Lock Screws
Figure 2-52 Fix the Speed Dome to Head Cover
Pendant Mounting
Notes:
For cement ceiling, you need to use the expansion screw to fix the bracket. The
mounting hole of the expansion pipe on the wall should align with the mounting
hole on the bracket.
For wooden ceiling, you can just use the self-tapping screw to fix the bracket.
Make sure that the ceiling is strong enough to withstand more than eight times the
weight of the speed dome and the accessories.
If you use the brackets the dealer recommends, the pendant adapter in the package
is not needed during installation. The included pendent adapter might be useful if
you use other brackets. The dimension of pendant adapter is G1
1
2
.
Figure 2-53 Supplied Pendant Adapter
Steps:
1. Fix the pendant mounting bracket to ceiling.