Quick Start Guide
Table Of Contents
- 1 Overview
- 1.1 Speed Dome Overview
- 1.1.1 Overview of Type I Speed Dome
- 1.1.2 Overview of Type II Speed Dome
- 1.1.3 Overview of Type III Speed Dome
- 1.1.4 Overview of Type IV Speed Dome
- 1.1.5 Overview of Type V Speed Dome
- 1.1.6 Overview of Type VI Speed Dome
- 1.1.7 Overview of Type VII Speed Dome
- 1.1.8 Overview of Type VIII Speed Dome
- 1.1.9 Overview of Type IX Speed Dome
- 1.2 Cable Interfaces
- 1.3 Alarm Output
- 1.1 Speed Dome Overview
- 2 Installation
- 2.1 Installing Type I Speed Dome
- 2.2 Installing Type II Speed Dome
- 2.3 Installing Type III Speed Dome
- 2.4 Installing Type IV Speed Dome
- 2.5 Installing Type V Speed Dome
- 2.6 Installing Type VI and VII Speed Dome
- 2.7 Installing Type VIII Speed Dome
- 2.8 Installing Type IX Speed Dome
- 2.9 Installation of Network Cable Waterproof Jacket
- 2.10 Installation of Water-proof Tape
- 2.11 Protective Measures for Outdoor Installation
- 3 Activate and Access Network Camera
Network Speed Dome·Quick Start Guide
29
Figure 2-45 Route the Cables
9. Align the speed dome back box with the head cover. Use the wrench to tighten the
lock screws to secure the speed dome and the bracket.
Lock Screw
Figure 2-46 Secure the Speed dome
10. Remove the protective film on the bubble after the installation is finished.
2.6 Installing Type VI and VII Speed Dome
Wall Mounting
Notes:
You can use wall mounting bracket alone, or you can use wall mounting bracket
together with a corner mounting bracket or a vertical pole mounting bracket to fix
the speed dome at a corner or on a pole.