Quick Start Guide

Network Speed Dome·Quick Start Guide
14
 Water-proof treatment is required for cable connectors. Refer to Section 2.9 and
2.10 for details.
Steps:
1. The ceiling mounting speed dome is installed with an in-ceiling bracket by default.
You need to remove the in-ceiling bracket first before you install the speed dome.
1). Loosen and remove the four screws as shown in Figure 2-15.
Figure 2-15 Remove the Screws
2). Remove the in-ceiling bracket as shown in Figure 2-16.
Figure 2-16 Remove the Bracket
3). Install four bolts to the screw holes as shown in Figure 2-17.