Quick Start Guide
Table Of Contents
- 1 Overview
- 1.1 Speed Dome Overview
- 1.1.1 Overview of Type I Speed Dome
- 1.1.2 Overview of Type II Speed Dome
- 1.1.3 Overview of Type III Speed Dome
- 1.1.4 Overview of Type IV Speed Dome
- 1.1.5 Overview of Type V Speed Dome
- 1.1.6 Overview of Type VI Speed Dome
- 1.1.7 Overview of Type VII Speed Dome
- 1.1.8 Overview of Type VIII Speed Dome
- 1.1.9 Overview of Type IX Speed Dome
- 1.2 Cable Interfaces
- 1.3 Alarm Output
- 1.1 Speed Dome Overview
- 2 Installation
- 2.1 Installing Type I Speed Dome
- 2.2 Installing Type II Speed Dome
- 2.3 Installing Type III Speed Dome
- 2.4 Installing Type IV Speed Dome
- 2.5 Installing Type V Speed Dome
- 2.6 Installing Type VI and VII Speed Dome
- 2.7 Installing Type VIII Speed Dome
- 2.8 Installing Type IX Speed Dome
- 2.9 Installation of Network Cable Waterproof Jacket
- 2.10 Installation of Water-proof Tape
- 2.11 Protective Measures for Outdoor Installation
- 3 Activate and Access Network Camera
Network Speed Dome·Quick Start Guide
12
Protective Sticker
Protective Foam
Back Box
Bubble
Figure 2-10 Remove the Protective Accessories
5. Drill a hole on the ceiling according to the drill template (supplied).
Note:
±2 mm of the circle diameter is tolerable.
Φ 224
Unit: mm
Figure 2-11 Drill a Hole on the Ceiling
6. Connect the cables.
7. Install the speed dome to the ceiling.
1). Loosen the two lock screws on both sides of the back box and make the locks in
internal position as shown in Figure 2-12.
Lock
Lock
Figure 2-12 Locks and Lock Screws