User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Accessing to the Network Speed Dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- 5.1 Storage Settings
- 5.2 Basic Event Configuration
- 5.3 Smart Event Configuration
- 5.4 PTZ Configuration
- 5.4.1 Configuring Basic PTZ Parameters
- 5.4.2 Configuring PTZ Limits
- 5.4.3 Configuring Initial Position
- 5.4.4 Configuring Park Actions
- 5.4.5 Configuring Privacy Mask
- 5.4.6 Configuring Scheduled Tasks
- 5.4.7 Clearing PTZ Configurations
- 5.4.8 Configuring Smart Tracking
- 5.4.9 Prioritize PTZ
- 5.4.10 Position Settings
- 5.4.11 Rapid Focus
- 5.5 Face Capture Configuration
- Chapter 6 Camera Configuration
- Appendix
© Hikvision
than 0, the error data will be corrected via redundant data that is added to the stream and
data retransmission. The higher the value is, the more redundant date will be generated, the
more data error will be corrected, and the larger bandwidth is required. When the proportion
is 100, the redundant data will be as large as the original data, and the bandwidth is twice
required.
Note:
Be sure the bandwidth is sufficient in Error Correction mode.
5. Save the settings.
Figure 6-21 Smooth Streaming
HTTP Listening
Purpose:
Alarm information can be sent to destination IP or Host via HTTP protocol.
Steps:
1. Input destination IP or host name, URL, and port number.
2. Click Test to see if the service is available.
Note:
HTTP data transmission should be supported by the destination IP or Host.
3. Save the settings.
Figure 6-22 HTTP Listening