Quick Start Guide
Table Of Contents
- 1 Overview
- 1.1 Speed Dome Overview
- 1.1.1 Overview of Type I Speed Dome
- 1.1.2 Overview of Type II Speed Dome
- 1.1.3 Overview of Type III Speed Dome
- 1.1.4 Overview of Type IV Speed Dome
- 1.1.5 Overview of Type V Speed Dome
- 1.1.6 Overview of Type VI Speed Dome
- 1.1.7 Overview of Type VII Speed Dome
- 1.1.8 Overview of Type VIII Speed Dome
- 1.1.9 Overview of Type IX Speed Dome
- 1.2 Cable Interfaces
- 1.3 Alarm Output
- 1.1 Speed Dome Overview
- 2 Installation
- 2.1 Installing Type I Speed Dome
- 2.2 Installing Type II Speed Dome
- 2.3 Installing Type III Speed Dome
- 2.4 Installing Type IV Speed Dome
- 2.5 Installing Type V Speed Dome
- 2.6 Installing Type VI and VII Speed Dome
- 2.7 Installing Type VIII Speed Dome
- 2.8 Installing Type IX Speed Dome
- 2.9 Installation of Network Cable Waterproof Jacket
- 2.10 Installation of Water-proof Tape
- 2.11 Protective Measures for Outdoor Installation
- 3 Activate and Access Network Camera
Network Speed Dome·Quick Start Guide
42
5. Connect the cables, and align the speed dome with the head cover, using wrench to
tighten the screws on the head cover.
Figure 2-77 Finish the installation
2.8 Installing Type IX Speed Dome
Wall Mounting
Notes:
You can use a wall mounting bracket alone, or you can use a wall mounting bracket
together with a corner mounting bracket or a vertical pole mounting bracket to fix
the speed dome at a corner or on a pole.
The brackets are not included. You should purchase separately.
Wall mounting bracket
Wall mounting bracket +
corner mounting bracket
Wall mounting bracket +
vertical pole mounting
bracket
Figure 2-78 Brackets for Installation
For cement wall, you need to use the expansion screw to fix the bracket. The
mounting hole of the expansion pipe on the wall should align with the mounting
hole on the bracket.
For wooden wall, you can just use the self-tapping screw to fix the bracket.