User's Manual

Figure 11-6 Draw Area
8. Click Sav
e.
9. Repeat above steps to set other regions.
10. Set arming schedule. See Set Arming Schedule .
11. Set linkage method. See Linkage Method Sengs .
11.2.5 Set Region Exing Detecon
Region exing detecon is used to detect the objects movement of exing from a predened area.
When it occurs, the device takes linkage acons as response.
Step
s
1. Go to Conguraon → Event → Smart Event → Region Exing Detecon .
2. Check Enable.
3. Oponal: Click Lock to lock PTZ control to prevent the in
terrupon from other PTZ related
acon during conguraon.
Normally, the PTZ control is automacally locked when you enter the conguraon interface.
You can manually resume the lock when the countdown is over.
4. Adjust the live image to the desired scene by using PTZ control buons.
5. Draw de
tecon area.
1) Select a Region No.. Up to 4 regions can be set.
2) Click Detecon Area.
3) Click on the live image to draw the boundaries of the detecon area, and right click to
comple
te drawing.
6. Oponal: Set the minimum size and the maximum size for the target to improve detecon
accuracy. Only targets whose size are between the maximum size and the minimum size trigger
the detecon.
1)
Click Max. Size, and drag the mouse on live image. If you want to change the size, click the
buon and draw again.
Network Speed Dome User Manual
79