User's Manual

Go to image parameters switch seng page: Conguraon → Image → Image Parameters Switch ,
and set parameters as needed.
Set Scheduled-switch
Switch the image to the linked scene mode automacally in certain me periods.
Steps
1. Check Scheduled-switch.
2. Select and congure the corresponding me period and linked scene mode.
Note
For Linked Scene conguraon, refer to Scene Mode .
3. Click Save.
Se
t Link to Preset
You can set a preset to switch the image to a linked scene.
Steps
1. Check Link to Preset.
2. Select a preset.
3. Check and set a me period and a linked scene mode.
4. Click Sav
e.
9.6.3 Mirror
When the live view image is the reverse of the actual scene, this funcon helps to display the
image normally
.
Select the mirror mode as needed.
Note
The video recording will be shortly interrupted when the funcon is enabled.
9.6.4 Video Standard
Video standard is an ability of a video card or video display device that denes the amount of
color
s that are shown and the resoluon. The two most common video standard used are NTSC
and PAL. In NTSC, 30 frames are transmied each second. Each frame is made up of 525 individual
scan lines. In PAL, 25 frames are transmied each sec
ond. Each frame is made up of 625 individual
scan lines. Select video signal standard according to the video system in your country.
Network Speed Dome User Manual
60