User's Manual

Note
The PTZ control is automacally locked to avoid interrupon during conguraon.
2. Set vericaon poin
ts.
1) Adjust the pan, lt, and zoom to nd the scene with a vericaon point.
2) Click
and click on the vericaon point on the live image.
The selected poin
t is zoomed in and placed in the center of the image.
3) Click
again.
A red cr
oss shows on the point.
4) Click Add and input the precise longitude and latude of the point.
5) Click
to save the pan, lt, and zoom value of the point.
6) Click Sa
ve.
7) Repeat the steps to set other vericaon points.
Numbered green and blue rectangles are displayed on the image. The blue rectangle marks
the PTZ posion of the vericaon point you set and the green rectangle marks the
calculated PTZ posion based on the longitude and latude you input. If the two rectangles
are close to each other, then the GPS calibraon succeeds.
Network Speed Dome User Manual
43