User's Manual

Table Of Contents
Note
Complete cercate management before selecng server cercate. Refer to Cercate
Management for de
tailed informaon.
When set up connecon between the device and the client soware, it is recommended to
use Enhanced SDK Service and set the communicaon in Arming Mode to encrypt the data
transmission. See the user manual of the client soware for the arming mode sengs.
TLS (Transport Layer Security)
The device
oers TLS1.1 and TLS1.2. Enable one or more protocol versions according to your
need.
Bonjour
Uncheck to disable the protocol.
3. Click Save.
13.11 Set Alarm Server
The device can send alarms to desnaon IP address or host name through HTTP, HTTPS, or ISUP
prot
ocol. The desnaon IP address or host name should support HTTP, HTTP, or ISUP data
transmission.
Steps
1. Go to Conguraon → Network → Advanced Sengs
→ Alarm Server .
2. Enter Desnaon IP or Host Name, URL, and Port.
3. Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during c
ommunicaon.
4. Click Test to check if the IP or host is available.
5. Click Sa
ve.
13.12 TCP Acceleraon
TCP acceleraon is used to improve latency and reduce packet loss caused by network congeson
in poor network condion, and guarantee the uency of live view.
13.13 Trac Shaping
Trac shaping is used to shape and smooth video data packet before transmission.
Network Speed Dome User Manual
99