User Manual

User Manual of Network Speed Dome

The system can be configured to send an Email notification to all designated

receivers if an alarm event is detected, e.g., motion detection event, video loss,

tamper-proof, etc.

Before you start:

Please configure the DNS Server settings under Basic Configuration > Network >

TCP/IP or Advanced Configuration > Network > TCP/IP before using the Email

function.

Steps:

1. Enter the Email Settings interface:

Configuration > Advanced Configuration > Network > Email

Figure 6-24 Email Settings

2. Configure the following settings:

Sender: The name of the email sender.

Sender’s Address: The email address of the sender.

SMTP Server: The SMTP Server IP address or host name (e.g.,

smtp.263xmail.com).

SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25.

Enable SSL: Check the checkbox to enable SSL if it is required by the SMTP

server.

Attached Image: Check the checkbox of Attached Image if you want to send

emails with attached alarm images.

Interval: The interval refers to the time between two actions of sending attached

pictures.

Authentication (optional): If your email server requires authentication, check

this checkbox to use authentication to log in to this server and enter the login