User Manual

User Manual of Network Speed Dome
© Hikvision
63
With the function enabled, you don’t need to configure the port mapping for each
port, and the camera is connected to the Wide Area Network via the router.
Steps:
1. Enter the UPnP™ settings interface.
Configuration >Advanced Configuration > Network > UPnP™
2. Check the checkbox to enable the UPnP™ function.
You can edit the Friendly Name of the speed dome. This name can be detected
by corresponding device, such as a router.
Figure 6-22 Configure UPnP Settings
6.3.10 Configuring NAT (Network Address Translation) Settings
Steps:
1. Set the port mapping mode:
To port mapping with the default port numbers:
Choose
To port mapping with the customized port numbers:
Choose
And you can customize the value of the port No. by yourself.
Figure 6-23 Configure the Port No.
2. Click to save the settings.
6.3.11 Configuring Email Settings
Purpose: