Quick Start Guide

E Series Network Speed Dome·Quick Start Guide
20
2.3.2 In-ceiling Mounting
Notes:
 The height of the space above the ceiling must be more than 250 mm.
 The thickness of the ceiling must range from 5 mm to 40 mm.
 The ceiling must be strong enough to withstand more than four times the weight of
the speed dome and the accessories.
Steps:
1. Disassemble the speed dome.
1) Rotate the bubble counterclockwise to separate it from the back box.
2) Remove the protective lens cover, foam, and sticker.
3) Install the memory card.
Protective Foam
Sticker
Bubble
Back Box
Figure 2-28 Disassemble the Speed Dome
4) Attach the bubble to the back box, and rotate clockwise to secure it.
2. Drill screw holes in the ceiling.
1) Attach the drill template to the ceiling where you want to install the speed
dome.
2) Cut a hole and drill screw holes according to the drill template.
Note:
±2 mm of the circle diameter is tolerable.
3. Install the speed dome to the ceiling.
1) Loosen the two lock screws on both sides of the back box and make the locks in
internal position as shown in Figure 2-29.