Quick Start Guide

E Series Network Speed Dome·Quick Start Guide
16
DE4xxxI Series (IR) Type I Speed Dome
Steps:
1. Install the memory card.
Note:
Refer to step 1 in Section 2.2.1 Wall Mounting.
2. Drill screw holes in the ceiling.
1) Attach the drill template to the ceiling where you want to install the speed
dome.
2) Cut a hole and drill screw holes according to the drill template.
Note:
±2 mm of the circle diameter is tolerable.
3. Route the cables through the ceiling for the speed dome.
4. Install the toggle bolts.
1) Remove the toggle from the toggle bolt.
2) Insert the bolts into the screw holes on the speed dome.
3) Rotate the bolts through the screw holes.
4) Install the toggles back as shown in Figure 2-20.
Toggle
Bolt
Figure 2-20 Install the Toggle Bolts
5. Install the speed dome to the ceiling.
1) Align the toggle bolts with the screw holes on the ceiling.
2) Push the speed dome to the mounting hole on the ceiling.