Quick Start Guide

E Series Network Speed Dome·Quick Start Guide
12
2.1.3 Ceiling Mounting
Notes:
 The thickness of the ceiling must range from 5 mm to 40 mm.
 The ceiling must be strong enough to withstand more than four times the weight of
the speed dome and the accessories.
 If the speed dome is installed to the wooden ceiling, use the self-tapping screws to
secure the mounting base.
 If the speed dome is installed to the cement ceiling, drill three Φ5 mm screw holes
onto the ceiling according to the position of the holes, and then secure the
mounting base to the ceiling with expansion screws.
Steps:
1. Disassemble the speed dome.
1) Loosen three screws and remove the bubble.
2) Remove the protective lens cover, foam, and sticker.
Protective Sticker
Bubble
Protective Foam
Figure 2-14 Disassemble the Speed Dome
3) Attach the bubble to the back box, and secure it with screws.
2. Install the memory card.
3. Drill screw holes in the ceiling.
1) Attach the drill template to the ceiling where you want to install the speed
dome.
2) Drill screw holes and a cable hole (optional) according to the drill template.
4. Install the speed dome to the ceiling.
1) Align the ceiling bracket with the screw holes on the drill template. And secure
the ceiling bracket to the ceiling with screws (supplied).
2) Align the hook of the ceiling with unlock label on the speed dome.
3) Push the speed dome to the ceiling bracket and rotate clockwise to secure it.