Quick Start Guide
Table Of Contents
- 1 Overview
- 2 Installation
- 2.1 Installing DE4xxx Series Speed Dome
- 2.2 Installing DE4xxxI Series (IR) Speed Dome
- 2.3 Installing DE5xxx Series Speed Dome
- 2.4 Installing DE5xxxI Series (IR) Speed Dome
- 2.5 Installing DE6xxxI Series (IR) Speed Dome
- 2.6 Installing DE7xxxI Series (IR) Speed Dome
- 2.7 Protective Measures for Outdoor Installation
- 3 Setting the Speed Dome over the LAN
- 4 Accessing via Web Browser
- 5 Operating via Hik-Connect App
E Series Network Speed DomeยทQuick Start Guide
11
Toggle
Bolt
Figure 2-11 Install the Toggle Bolts
5. Install the speed dome to the ceiling.
1) Align the toggle bolts with the screw holes on the ceiling.
2) Push the speed dome to the mounting hole on the ceiling.
3) Rotate the bolts again. The toggle will automatically rotate down to secure the
speed dome to the ceiling.
Ceiling
Toggle
Figure 2-12 Install the Speed Dome to the Ceiling
4) Secure the bubble to the back box with three screws as shown in Figure 2-13.
Screws
Figure 2-13 Secure the Bubble
6. Route the cables through the ceiling.
7. Remove the protective film on the bubble after the installation is finished.