Quick Start Guide

E Series Network Speed Dome·Quick Start Guide
9
Push
Rotate
Lock Screw
Figure 2-7 Align to the Bracket
5) Tighten the two SC-AM6 × 14 lock screws with the wrench to secure the speed
dome and the bracket.
4. Remove the protective film on the bubble after the installation is finished.
2.1.2 In-ceiling Mounting
Notes:
 The height of the space above the ceiling must be more than 250 mm.
 The thickness of the ceiling must range from 5 mm to 40 mm.
 The ceiling must be strong enough to withstand more than four times the weight of
the speed dome and the accessories.
Steps:
1. Disassemble the speed dome.
1) Loosen three screws and remove the bubble.
2) Loosen three screws and remove the back box.
3) Remove the protective lens cover, foam, and sticker.
Protective Foam
Protective Sticker
Bubble
Back Box
Figure 2-8 Disassemble the Speed Dome
2. Install the memory card.