User Manual

User Manual of E Series Network Speed Dome
© Hikvision
4
Chapter 2 Network Connection
Before you start:
 If you want to set the network speed dome via a LAN (Local Area Network), please refer to
Section 2.1.
 If you want to set the network speed dome via a WAN (Wide Area Network), please refer to
Section 2.2.
2.1 Setting the Network Speed Dome over the LAN
 You shall acknowledge that the use of the product with Internet access might be under
network security risks. For avoidance of any network attacks and information leakage, please
strengthen your own protection. If the product does not work properly, please contact with
your dealer or the nearest service center.
 To ensure the network security of the speed dome, we recommend you to have the speed
dome assessed and maintained termly. You can contact us if you need such service.
Purpose:
To view and configure the speed dome via a LAN, you need to connect the network speed dome
in the same subnet with your computer, and install the SADP or client software to search and
change the IP of the network speed dome.
For the detailed introduction of SADP, please refer to Appendix 1.
2.1.1 Wiring over the LAN
The following figures show the two ways of cable connection of a network speed dome and a
computer:
Purpose:
 To test the network speed dome, you can directly connect the network speed dome to the
computer with a network cable as shown in Figure 2-1.
 Refer to the Figure 2-2 to set the network speed dome over the LAN via a switch or a router.
Network Cable
Figure 2-1 Connecting Directly