User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Speed Dome
- Chapter 4 Live View
- Chapter 5 PTZ Configuration
- Chapter 6 Speed Dome Configuration
- 6.1 Configuring Local Parameters
- 6.2 Configuring Time Settings
- 6.3 Configuring Network Settings
- 6.3.1 Configuring TCP/IP Settings
- 6.3.2 Configuring Port Settings
- 6.3.3 Configuring PPPoE Settings
- 6.3.4 Configuring DDNS Settings
- 6.3.5 Configuring SNMP Settings
- 6.3.6 Configuring 802.1X Settings
- 6.3.7 Configuring QoS Settings
- 6.3.8 Configuring FTP Settings
- 6.3.9 Configuring UPnP™ Settings
- 6.3.10 Configuring NAT (Network Address Translation) Settings
- 6.3.11 Configuring Email Settings
- 6.3.12 Configuring Platform Access Settings
- 6.3.13 Configuring HTTPS Settings
- 6.4 Configuring Video and Audio Settings
- 6.5 Configuring Image Settings
- 6.6 Configuring and Handling Alarms
- 6.6.1 Configuring Motion Detection
- 6.6.2 Configuring Video Tampering Alarm
- 6.6.3 Configuring External Alarm Input
- 6.6.4 Configuring Alarm Output
- 6.6.5 Handling Exception
- 6.6.6 Detecting Audio Exception
- 6.6.7 Configuring Dual-VCA
- 6.6.8 Configuring Intrusion Detection
- 6.6.9 Configuring Line Crossing Detection
- Chapter 7 Record Settings
- Chapter 8 Playback
- Chapter 9 Log Searching
- Chapter 10 Others
- Appendix
User Manual of E Series Network Speed Dome
© Hikvision
79
configured.
(2) Select a Record Type. The record type can be Normal, Motion Detection, Alarm, Motion
| Alarm, Motion & Alarm.
Normal
If you select Normal, the video will be recorded automatically according to the time of
the schedule.
Record Triggered by Motion Detection
If you select Motion Detection, the video will be recorded when the motion is
detected.
Besides configuring the recording schedule, you have to set the motion detection area
and check the checkbox of Trigger Channel in the Linkage Method of Motion Detection
Settings interface. For detailed information, please refer to the Step 1 Set the Motion
Detection Area in the Section 6.6.1 Configuring Motion Detection.
Record Triggered by Alarm
If you select Alarm, the video will be recorded when the alarm is triggered via the
external alarm input channels.
Besides configuring the recording schedule, you have to set the Alarm Type and check
the checkbox of Trigger Channel in the Linkage Method of Alarm Input Settings
interface. For detailed information, please refer to Section 6.6.4 Configuring External
Alarm Input.
Record Triggered by Motion & Alarm
If you select Motion & Alarm, the video will be recorded when the motion and alarm
are triggered at the same time.
Besides configuring the recording schedule, you have to configure the settings on the
Motion Detection and Alarm Input Settings interfaces. Please refer to Section 6.6.1
and Section 6.6.4 for detailed information.
Record Triggered by Motion | Alarm
If you select Motion | Alarm, the video will be recorded when the external alarm is
triggered or the motion is detected.
Besides configuring the recording schedule, you have to configure the settings on the
Motion Detection and Alarm Input Settings interfaces. Please refer to Section 6.6.1
and Section 6.6.4 for detailed information.