User Manual

User Manual of E Series Network Speed Dome
© Hikvision
73
after you enter the line crossing detection interface. Optionally, you can click the
button to manually activate the movement, or lock the movement when the button turns to
by clicking it.
Figure 6-53 Configuring Line
5. Draw area.
1) Click to draw a line on the image.
2) Click the line to switch to the editing mode.
Click and drag an end to the desired place to adjust the length and angle of the line. And
click and drag the line to adjust the location.
Up to four lines are supported.
6. Configure the parameters for each defense region separately.
 Direction: Select the detection direction in the dropdown list, there are A<->B, A->B and
B->A selectable.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which
can trigger the alarm, when the sensitivity is high, a very small object can trigger the
alarm.
7. Click to edit the arming schedule for line crossing detection. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection. Refer to
Step 2 in Section 6.6.1 Configuring Motion Detection.
8. Check the checkbox to select the linkage method taken for the line crossing detection. Notify
surveillance center, send email, upload to FTP, trigger channel, smart tracking and trigger
alarm output are selectable. Please refer to Step 3 in Section 6.6.1 Configuring Motion