User Manual

User Manual of E Series Network Speed Dome
© Hikvision
68
Figure 6-48 Linkage Method
6.6.4 Configuring Alarm Output
Steps:
1. Enter the Alarm Output Settings interface:
Configuration>Advanced Configuration> Basic Event > Alarm Output
2. Select one alarm output channel in the Alarm Output drop-down list.
3. Set a name in for the alarm output
(optional).
4. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or Manual. The
delay time refers to the time duration that the alarm output remains in effect after alarm
occurs.
5. Click to enter the Edit Schedule Time interface. The time schedule configuration
is the same as the settings of the arming schedule for motion detection. Refer to Step 2 Set
the Arming Schedule for Motion Detection in Section 6.6.1 Configuring Motion Detection.
6. You can copy the settings to other alarm outputs.
7. Click to save the settings.