User Manual

User Manual of E Series Network Speed Dome
© Hikvision
66
To trigger an alarm output when an event occurs, please refer to Section 6.6.4
Configuring Alarm Output to set the alarm output parameters.
6.6.2 Configuring Video Tampering Alarm
Purpose:
You can configure the speed dome to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the Video Tampering Settings interface :
Configuration > Advanced Configuration > Basic Event > Video Tampering
Figure 6-46 Tampering Alarm
2. Check Enable Video Tampering checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 1 Set the Motion Detection Area in Section 6.6.1
Configuring Motion Detection.
4. Click to edit the arming schedule for tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection. Refer to
Step 2 Set the Arming Schedule for Motion Detection in Section 6.6.1 Configuring Motion
Detection.
5. Check the checkbox to select the linkage method taken for the tampering. Notify surveillance
center, send email and trigger alarm output are selectable. Please refer to Step 3 Set the
Alarm Actions for Motion Detection in Section 6.6.1 Configuring Motion Detection.
6. Click to save the settings.