User Manual

User Manual of E Series Network Speed Dome
© Hikvision
27
1. Enter the Basic PTZ Parameter Configuration interface:
Configuration > Advanced Configuration > PTZ > Basic
Figure 5-2 Basic PTZ Configuration Interface
2. Configure the following settings:
 Basic Parameters: Enable/disable proportional pan and preset freezing, set the preset speed,
keyboard control speed, and auto scan speed.
 Proportional Pan: If you enable this function, the pan/tilt speeds change according to
the amount of zoom. When there is a large amount of zoom, the pan/tilt speed will be
slower for keeping the image from moving too fast on the live view image.
 Preset Speed: You can set the speed of a defined preset from 1 to 8.
 Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low, Normal
or High.
 Auto Scan Speed: The dome provides 5 scan modes: auto scan, tilt scan, frame scan,
random scan and panorama scan. The scan speed can be set from level 1 to 40.
 Zooming Speed: The speed of zooming is adjustable.
 Manual Control Speed: The manual control speed can be set as Compatible, Pedestrian,
Non-motor Vehicle, Motor Vehicle or Self-adaptive.
 Compatible: The control speed is same as the Keyboard Control Speed.
 Pedestrian: Choose the Pedestrian when you monitor the pedestrians.
 Non-motor Vehicle: Choose the Non-motor Vehicle when you monitor the
non-motor vehicles.
 Motor Vehicle: Choose the Motor Vehicle when you monitor the motor vehicles.
 Self-adaptive: You are recommended to set the Self-adaptive when the application
scene of the speed dome is complicated.
 PTZ OSD: Set the on-screen display duration of the PTZ status.
 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds, 10
seconds, Always Close or Always Open.
 PT Status: Set the azimuth angle display duration while panning and tilting as 2 seconds,