User Manual

User Manual of E Series Network Speed Dome
© Hikvision
26
Chapter 5 PTZ Configuration
5.1 Configuring Initial Position
Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial position.
You can also customize the initial position according to your own demand.
 Customize an Initial Position:
Steps:
1. Enter the Initial Position Configuration interface:
Configuration > Advanced Configuration > PTZ > Initial Position
Figure 5-1 PTZ Configuration
2. Click the PTZ control buttons to find a position as the initial position of the dome; you can
also call a defined preset and set it as the initial position of the dome.
3. Click Set to save the position.
 Call/delete an Initial Position:
You can click to call the initial position. You can click to delete the initial
position and restore the factory default initial position.
5.2 Configuring Basic PTZ Parameters
Purpose:
You can configure the basic PTZ parameters, including proportional pan, preset freezing, preset
speed, etc.