User Manual

User Manual of E Series Network Speed Dome
© Hikvision
21
1. In the PTZ control panel, select a preset number from the preset list.
Figure 4-4 Setting a Preset
2. Use the PTZ control buttons to move the lens to the desired position.
• Pan the speed dome to the right or left.
• Tilt the speed dome up or down.
• Zoom in or out.
• Refocus the lens.
3. Click to finish the setting of the current preset.
4. You can click to delete the preset.
You can configure up to 256 presets.
 Calling a Preset:
In the PTZ control panel, select a defined preset from the list and click to call the preset.
Figure 4-5 Calling a Preset
For convenient preset selection, refer to the following steps to navigate to the preset you want.
Steps:
1. Select any preset from the list.
2. Click the preset number you need on the keyboard.
The following presets are predefined with special commands. You can only call them but
not configure them. For instance, preset 99 is the “Start auto scan”. If you call the preset 99, the