User Manual

User Manual of E Series Network Speed Dome
© Hikvision
99
of 200. E.g. if the 8000 port is changed to 8005, then the 8200~8210 ports should be
changed to 8205~8215.
Example:
When the speed domes are connected to the same router, you can forward the ports of a
speed dome as 80, 8000, 8200~8210 and 554 with IP address 192.168.1.23, and the
ports of another speed dome as 81, 8001, 8201~8211 and 555 with IP 192.168.1.24.
Refer to the steps as below:
Steps:
1. As the settings mentioned above, forward the port 80, 8000, 8200~8210 and 554 for the
network speed dome at 192.168.1.23
2. Forward the port 81, 8001, 8201~8211 and 555 for the network speed dome at 192.168.1.24.
3. Enable ALL or TCP protocols.
4. Check the Enable checkbox and click .
Figure A.2.3 Port Mapping
The port of the network speed dome cannot conflict with other ports. For example,
some web management port of the router is 80. Change the speed dome port if it is the
same as the management port.