User's Manual

3. Select Hik-Connect as the Plaorm Access Mode.
4. Check Enable.
5. Click and r
ead "Terms of Service" and "Privacy Policy" in pop-up window.
6. Create a vericaon code or change the old vericaon code for the camera.
Note
The
vericaon code is required when you add the camera to Hik-Connect service.
7. Sa
ve the sengs.
Enable Hik-Connect Service via SADP Soware
This part introduce how to enable Hik-Connect service via SADP soware of an acvated camera.
Steps
1. Run SADP soware.
2. Select a camera and enter Modify Network Parameters page.
3. Check Enable Hik-Connect.
4. Create a vericaon code or change the old vericaon code.
Note
The
vericaon code is required when you add the camera to Hik-Connect service.
5. Click and r
ead "Terms of Service" and "Privacy Policy".
6. Conrm the sengs.
10.7.2 Set Up Hik-Connect
Steps
1. Get and install Hik-Connect applicaon by the following ways.
-
Visit
hps://appstore.hikvision.com to download the applicaon according to your mobile
phone s
ystem.
-
Visit the ocial site of our company. Then go to Support → Tools → Hikvision App Store .
-
Scan the QR code below to download the applicaon.
Note
If errors like "Unknown app" occur during the installaon, solve the problem in two ways.
•
Visit
hps://appstore.hikvision.com/stac/help/index.html to refer to the troubleshoong.
• Visit hps://appstore.hikvision.com/ , and click Installaon Help a
t the upper right corner of
the interface to refer to the troubleshoong.
2. St
art the applicaon and register for a Hik-Connect user account.
3. Log in aer registraon.
Network Speed Dome User Manual
74