User's Manual

Refer to Set FTP to set the FTP server.
Refer to Set NAS for NAS conguraon.
Refer to Set Memory Card for memory card storage conguraon.
9.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
informaon when an alarm event is detected.
For email sengs, refer to Set Email .
Set Email
When the email is congured and Send Email is enabled as a linkage method, the device sends an
email nocaon to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email funcon. Go to Conguraon → Network → Basic
Sengs → TCP/IP for DNS sengs.
Steps
1. Go t
o email sengs page: Conguraon → Network → Advanced Sengs → Email .
2. Set email parameters.
1) Input the sender's email informaon, including the Sender's Address, SMTP Server, and
SMTP Port.
2) Oponal: If y
our email server requires authencaon, check Authencaon and input your
user name and password to log in to the server.
3) Set the E-mail Encrypon.
• When you select SSL or TLS, and disable STARTTLS, emails are sent aer encrypted by SSL
or TLS. The SMTP port should be se
t as 465.
• When you select SSL or TLS and Enable STARTTLS, emails are sent aer encrypted by
STARTTLS, and the SMTP port should be set as 25.
Note
If you want to use STARTTLS, make sure that the protocol is supported by your email
ser
ver. If you check the Enable STARTTLS while the protocol is not supported by your email
sever, your email is sent with no encrypon.
4) Oponal: If y
ou want to receive nocaon with alarm pictures, check Aached Image. The
nocaon email has 3 aached alarm pictures about the event with congurable image
c
apturing interval.
5) Input the receiver's informaon, including the receiver's name and address.
6) Click Test to see if the funcon is well congured.
3. Click Sa
ve.
Network Speed Dome User Manual
64