User's Manual

4.11 Set Device Posion
Before You Start
Go to Conguraon → P
TZ → Basic Sengs → PTZ OSD to enable PT Status display.
Use other direcon
indicang devices to nd the North at the device locaon.
Steps
1. Go to Conguraon → PTZ → Posion Sengs .
2. Manually set device direcon by selecng the P
T Mode as Manual.
1) Adjust the lt
posion of the device to 0 by controling the up arrow and down arrow on the
PTZ panel.
2) Adjust the pan posion to show the live view of the north direcon by controling the le
arrow and right arrow on the PTZ panel.
3) Click Set as North.
3. Input the longitude and latude of the device manually.
4. Click Save.
What to do next
If you lost direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
4.12 Set Power O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a
power-o.
Steps
1. Go to Conguraon → PTZ → Basic Sengs .
2. Select Resume Time Point. When the device stays at one posion for the set resume me point
or mor
e, the posion is saved as a momory point. The device returns to the last memory point
when it restarts.
3. Click Save.
4.13 Set PTZ Priority
The funcon can set the PTZ priority of dierent signals.
St
eps
1. Go to Conguraon → PTZ → Priorize PTZ .
2. Set the priority signal and delayed me.
Network
The ne
twork signal controls the device with priority.
RS-485
Network Speed Dome User Manual
20