Network PTZ Camera Quick Start Guide 0
A 1 DC12 V IN 2 3 .. 4 5 6 B a./b. 2.
a. ② ① b. ② ① c.
C C1 C2.
C2.2 C3.1 C3.
C3.3 C3.4 C3.
D 1 2 6
E ② ① OUT (n) OUT (n) + DC - GND OUT ③ 30 VDC 1A ④ (10A 250VAC) ~220VAC L N ① OUT (n) OUT (n) F F2 F1 7
(Page 6 – D) 1. Install network cable waterproof jacket. 2. Use supplied waterproof tape to protect cable connectors and unused cables. Alarm Output (Page 7 – E) ① Relay output ② DC load ③ Power supply ④ JQC-3FG Relay Protective Measures for Outdoor Installation (Page 7 – F1) Activate and Access Network Camera (Page 7 – F2) English Product appearance is for reference only and may differ from the actual product. Cable Description (Page 1 – A) Notes: The cables vary depending on different camera models. 1.
PERMITTED BY APPLICABLE LAW, THIS MANUAL AND THE PRODUCT DESCRIBED, WITH ITS HARDWARE, SOFTWARE AND FIRMWARE, ARE PROVIDED “AS IS” AND “WITH ALL FAULTS AND ERRORS”. HIKVISION MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR OWN RISK.
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.
operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
hour after switching off before handling parts. The device with this sticker is intended for installation in a restricted access location. Access can only be gained by service persons or by users who have been instructed about the reasons for the restrictions applied to the location and about any precautions that shall be taken. Installation Install the equipment according to the instructions in this manual.
of 200 mm is classified as Risk Group 1 (RG1). Possible hazardous optical radiation emitted from this product. DO NOT stare at operating light source. May be harmful to the eyes. If appropriate shielding or eye protection is not available, turn on the light only at a safe distance or in the area that is not directly exposed to the light when installing or maintaining the device.
UD21713B
