User Manual

6. Align the camera with the back box/base plate, and
tighten the screws to secure the camera with the
back box/base plate.
Type I Camera
Figure 2-18 Fix the camera to the Ceiling
7. Connect the corresponding cables, such as power
cord, and video cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Type I Camera
0° to
355°
0° to 355°
0° to 75°
Figure 2-19 3-Axis Adjustment
9. Fit the black liner back to the camera and tighten
the screws on the bubble of the dome camera to
finish the installation.
2.3.2 Wall Mounting
Before you start:
You need to purchase a wall mount first.
Steps:
1. Drill four screw holes in the wall according to the
holes of the bracket.
2. Attach the mount to the wall by aligning the four
screw holes of the mount with expansion screws on
the wall.
3. Secure the mount with four hex nuts and washers.
Type I Camera
Figure 2-20 Install Wall Mounting Bracket
4. Refer to step 3 of 2.3.1Ceiling Mounting to remove
dome camera’s bubble and the black liner.
5. Attach the back box/base plate of the dome camera
to the wall mount, and secure them with supplied
screws.