User Manual

Figure 2-15 Fix the Junction Box
8. Repeat steps 5 to 9 of 2.2.1 Ceiling/Wall Mounting
without Junction Box to complete the installation.
2.3 Installation of Type III Camera
2.3.1 Ceiling Mounting
Before you start:
Both wall mounting and ceiling mounting are suitable
for the dome camera. Ceiling mounting will be taken as
an example in this section. And you can take steps of
ceiling mounting as a reference for wall mounting.
Steps:
1. Paste the drill template to the celling.
2. Drill screw holes and the cable hole (optional) on
the ceiling according to the supplied drill template.
Note:
Drill the cable hole when adopting the ceiling outlet
to route the cable.
Type I Camera
Figure 2-16 The Drill Template
3. Loosen the screws on the bubble of the dome
camera to remove the bubble and the black liner.
4. Attach the back box of type I camera/base plate of
type II camera to the ceiling, and secure them with
supplied screws.
Type I Camera
Figure 2-17 Attach the Back Box/Base Plate
Note:
 The supplied screw package contains self-tapping
screws, and expansion bolts.
 For cement ceiling/wall, expansion bolts are
required to fix the camera. For wooden ceiling/wall,
self-tapping screws are required.
5. Route the cables through the cable hole, or the side
opening.