User Manual

5. Route the cables through the cable hole, or the side
opening.
6. Align the camera with the back box/base plate, and
tighten the screws to secure the camera with the
back box/base plate.
Type I Camera
Type II Camera
Figure 2-3 Fix the camera to the Ceiling
7. Connect the corresponding cables, such as power
cable and video cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Type I Camera
0° to
355°
0° to 355°
0° to 75°
0° to355°
0° to 355°
0° to75°
Type II Camera
Figure 2-4 3-Axis Adjustment
9. Fit the black liner back to the camera and tighten
the screws on the bubble of the dome camera to
finish the installation.
2.2 Wall Mounting with a Braket
Before you start:
You need to purchase a wall mounting bracket
separately.
Steps:
1. Drill 4 screw holes in the wall according to the holes
of the bracket.
2. Attach the bracket to the wall by aligning the 4
screw holes of the bracket with expansion screws on
the wall.
3. Secure the bracket with 4 hex nuts and washers.
Type I Camera
Type II Camera
Figure 2-5 Install Wall Mounting Bracket