User Manual

UM DS-2CE5xH0T-Axxxxx 042318NA 7
• For a cement ceiling, expansion bolts are required
to fix the camera. For a wooden ceiling, self-
tapping screws are required. 
5. Route the cables through the cable hole or the
side opening.
6. Align the camera with the back box/base plate,
and tighten the screws to secure the camera with
the back box/base plate.
Figure 6 Fix the camera to the Ceiling
7. Connect the corresponding cables such as power
cord and video cable.
8. Power on the camera to check whether the
image on the monitor is at an optimum angle. If
not, adjust the camera according to the figure
below to get an optimum angle.
Figure 7 3-Axis Adjustment
9. Fit the black liner back to the camera and tighten
the screws on dome camera bubble to finish the
installation.
3.2 Type I and Type II Camera Wall Mounting
Before you start:
You must purchase a wall mount.
Steps:
1. Drill four screw holes in the wall according to the
holes of the mount.
2. Attach the mount to the wall by aligning the four
screw holes of the mount with expansion screws
on the wall.
3. Secure the mount with four hex nuts and
washers.