User Manual

UM DS-2CEx6H0T-xxITxF 042618NA 12
Note:
Cable hole is required when using the ceiling outlet to
route cables.
3. Loosen the set screws with a hex wrench (supplied)
to remove the bubble.
Figure 18 Remove the Bubble
4. Fix the mounting base on the ceiling with supplied
screws.
Figure 19 Fix the Mounting Base
5. Route the cables through the cable hole, or the
side opening.
6. Connect the corresponding cables, such as power
cord, and video cable.
7. Power on the camera to check if the image on the
monitor is at an optimum angle. If not, adjust the
camera according to the figure below to get an
optimum angle.
Figure 20 Type I Camera 2-Axis Adjustment